2012 Car
- Jimmy and Ian spent a solid day working on the wiring harness
- Ian finalized a number of items on the oil, water and fuel plumbing
- John fabricated an oil separator replaced loose lug studs
- Fixed leaking LR wheel and replaced wheel center
- Matt & I started on plug for new nose mold using a little bit of the 2005 car
- Preparing the engine for installation
- Added oil fitting for Accusump, very tight quarters due to exhaust manifold
- Fabricated baffle for oil pan
- Machined new spacers for engine mounts
- Purchased and installed new drive sprocket
- Installed port for new water temperature gauge sender
- Modified stock crank trigger wheel so tooth #1 is at TDC of cylinder #1.
- Fabricated new swirl pot and simplified radiator plumbing
- Replaced missing brake fluid reservoir and added spacers to adjust pedal position on cluster
- Fabricated mounts for damper reservoirs
- Repaired mounting tabs on fuel tank
- Purchased new fuel pump, filter, plumbing and fabricated new mount
- Fabricated new clutch cable mount on engine for better clearance to frame and water lines
